[moggyjim]

Thanks for letting me know who are or were M&G?.

[moggyjim]

i have the same model and the rod is correct and a mason jar does indeed fit.

Attachments:

1. 

[moggyjim]

thanks for the hospitality Charlies marquee is a show saver.

[moggyjim]

thanks for the info i will get myself some extensions and move the wheels out

[moggyjim]

now have some pictures i know the reverse belt is not right as this will drive fowrward.

Attachments:

1. 
2. 
3. 
4. 

[moggyjim]

will take some pictures tomorrow is it would be a nightmare to describe.

[moggyjim]

looks like post box red if i am going to paint i would love some decals but the ones on fleabay do not cover this model??

[moggyjim]

i have used the clone coils with no problem. But i look out on the internet sites for used genuine ones from scrapped mowers. My titan gt has a 7hp briggs and that has a bigger version of the magnatron . If the paint has gone from the shroud and has no sticker you can tell the size by the number of bolts holding the shroud on, one bolt at the top 5hp two bolts at the top 7hp. Hope this helps.

[moggyjim]

what size briggs engine did they fit to the 350?howard i need some info for another project.

[moggyjim]

yes mine is the earlier model i have a 5hp shroud and it is miles to small. There is little wear on the machine just a shame no blower cover???

[moggyjim]

Yes is was used as a paddock mower and spent its life outside.the engine has compression and the 3 pin coil so no points to worry about.I am not sure if the cowl size varies from hp to hp so not sure what to chase down.

[moggyjim]

The angle iron chassis is 1 and a half by 1 and a half.Dimensions are 48 inches long 33 inches wide and the two timber runners are 4 foot long hope this helps i am rebuilding mine and possibly extending the main frame so i can sit in front instead of in the truck. Hope this helps.

Attachments:

1. 
2. 

[moggyjim]

with a bit of luck there are pictures attached the bracket dimensions are as follows pivot brackets 4inches by 4 and a half 2 inches along the bottom and 5 inches across the angle the tube/ pivot is 1 inch diameter. the front brackets are5 inches long and 1 inch and a half wide

Attachments:

1. 
2. 
3. 

[moggyjim]

my id number starts with a P so i know it is a professional model is it just the engine that sets them apart or do i have a better chain case etc..

[moggyjim]

have an arm with holes you can have found, it in my spares pile.

[Author]

Posts