enginear

Ref flywheel unfortunately the mark left by the key shearing was difficult to place exactly so it was just as near as i could get,as for getting a key slot cut it’s down to cost as well as position,cheaper to buy new flywheel but what is a ten year old machine worth £28+ on bay !,when i have come across this problem of key shearing before yes…[Read more]

Just to add when refitting bolt’s or nut’s use a small amount of copper grease on the thread’s this will enable them to be undone at a future date as long as the nut or bolt is not required to be thread locked,i have used copper grease for many year’s on agricultural machine’s even if it’s not me that would dismantle it again….

REf the chamberlin tractor it would be no good over here many year’s i had to fit wider wheel spacer’s to a Ford FW30 [steiger american tractor sprayed blue]about 265hp it started off with single wheel’s then double’s using spacer’s between the wheel’s but when it was being used on an old hop farm in Kent and it was wet the space between the…[Read more]

REF the County seahorse when i worked ar Doe’s we looked sfter one of these belonged to [AWRE atomic weapon’s research establishment] on fouloness island and wash used at one time to recover fired shell’s from the mudflat’s,a pig to work on. REF the sub i took a photo of that year’s ago i was with an aircraft recovery group and it had been…[Read more]

AND A MARRY XLMASS FLOM SAANTAA,HIC HIC HIC,TO ALL

QUOTE

REMEMBER LIFE IS MEASURED NOT BY THE BREATH’S WE TAKE,
BUT BY THE MOMENT’S THAT TAKE OUR BREATH.

As WP say’s about an ungoverned engine yes this is normal, put the machine into work cutting grass and the rpm would drop pretty quick then you will find that you would need to open the throttle to get it to cut, the heavier the work the more the throttle need’s to be opened, if the engine was a four stroke doing the same work it would be governed…[Read more]