sidevalve@44

Have just looked on the Frosts site and their basic POR15 looks good value @ £11.82 (don’t mind paying that) Cheaper than the Caswell I referred to above.

Might get some of that.

Thanks Charlie,

The inside looks fairly clear of loose rust. The main concern I have, is whether the petrol will react with the Kurust treated surface that the tank now has.

I suppose I could fit an inline fuel filter. Hitchcocks Motorcycles (A Royal Enfield specialist; I used to own one) sell two types (a cheap one and a dear one !). They also…[Read more]

Problem solved. I have just purchased a bag of 10 x 1/2″UNF LH thread half nuts from McGill Motorsport in Scotland. (apparently they are used on Rose Joints on racing cars)

Although only half nuts they are actually quite thick and two used together should work fine.

Thanks.

Damn, I scrapped one of those a few years back !

Thanks for that, I will certainly bear it mind. Of course, the one thing I haven’t done yet is go to my local mower shop; they’ve probably got dozens of them on the shelf (not)!

A couple of photos showing the crank end and the Left handed thread.

Just to follow up. The shaft is parallel and the impeller came off very easily using a 3 legged puller.
The actual impeller is inside a static housing which is part of the bearing housing attached to the engine’s crankcase.
I used the puller on this housing and it all came off together.

Assuming the coil is OK, don’t waste time replacing the points, fit a Magnetron breakerless kit Pt No. 394970 (£23.70 from Briggsbits). It’s easy to fit (even I managed it !), you can leave the points insitu (after snipping the wires) and never have to worry about them again.

Hi Alison,

Yours looks in slightly better condition than mine and has the original wooden roller at the front, whereas mine has the later plastic ones, probably retrofitted; as the wooden ones can split and were generally replaced with plastic ones from the mid 70s on.

As to value; I’m not sure we can put prices etc., on here but, you could get…[Read more]

Thanks. I now have some useful info to work on. Someone on another forum has stated that Pegson Pumps with JAP or Villiers engines have RH thread so, mine should be no different.

I have a copy of the B&S parts list and unfortunately, it is generic and doesn’t show the crank end.

Must admit I haven’t made a serious attempt to remove the…[Read more]

Ha ha ! She came in to see what I was doing. Couldn’t resist putting the photo on !

Thanks for the info guys. Unfortunately can’t soak in diesel as the fluid would run out past the impeller vanes. Have sprayed liberally with GT85, and will use my garden flame thrower to try heating it up.
However, does anyone know if it is LH or RH thread ? Logic would suggest LH but, the Flywheel nut on the other side is LH thread, which is odd…[Read more]

That was a good find. Looks like all it needs is a bit of a clean up, some new wooden handle-grips and no doubt, a drop of oil on the axle !

What better way to get your Granddaughter to help in the garden.

Thanks for the info. Yes, I fitted one of those magnetron kits to a 1976 3Hp on a Wizard Rotavator. Starts easily and no worries about points wearing out.
Have been in touch with Graham at Briggsbits who has advised which one to go for.