mickattwo

My post should say Shay Rotogardener, I have all the paperwork and parts diagramsbut only Shay’s own part numbers. My problem may be the drive setup.

Charlie the inner cable is attached to the slide in the carb and wont come fully out. The carb is an AMAL the engine is Villiers from a Ransome 14 lawnmower. I do not know much about carbs but I understand that Villiers used several types on the same model engine.

I wish they were mine, very nice condition

If the plough used is vintage it should not be a concern if the power source is not. Is this correct?

THERE IS ALWAYS A WAY ROUND PROBLEMS

GOOD TURNOUT AND GOOD WEATHER WELL DONE ALL ENTRANTS

Good pictures and a good day weatherwise and good ploughing conditions

My blacksmith friend says it is for knocking into brickwork etc and he has made 100’s in his time Ud for clothes linetc

I have and use a “Bulldog” billhook. Does a good job . but is very pitted and not well forged No other markings probably counterfiet

same from me

Bulldog was a brand of hedgelayers and forest hand tools probably amalgamated with Hortag to make the tractor

Looks good for 90+ years

I know of Howard ploughs but they don’t look big enough for competition ploughing. Anyone can help me with Howard ploughs?

Hi I have a Honda F510, not as old as yours but I order parts from my local garden m/c dealer, they are very helpful and they have the parts disc. Send me a PM and let me know what you are needing. My Honda uses SAE 30 oil for both engine and gearbox. Honda parts are expensive. I would help with getting what you require.

Thanks for the info so far but neither flywheel has any markings but I have to remove both to check points, the date stamp may be on the inside somewhere. Are there any electronic modules for any of these engines as both machines will be working on a regular basis?